Magigoo Original 50ml

All you need for sure adhesion of 3D prints Magigoo is an easy to use 3D printing adhesive designed to address ‘the first layer not sticking problem’. Magigoo ensures a strong adhesion to the hot plate. But the magic starts when printing is ready: just wait for the plate to cool down and then remove your prints with just a finger flick! In addition, Magigoo helps to prevent warping. Isn’t it magic? Regardless of you being a hobbyist or professional – it is extremely rewarding to have a 30 hour print complete without any warping and having it release easily once cooled.

• Over 100 applications
• ABS, PLA, PETG, HIPS, ASA, TPU
• Easy application
• Easy release
• Easy clean
• No smell
• Non-toxic
• No additional tools needed
• Easy to transport
• Nicer print finish

HOW: 

Magigoo has been designed and tested to work with different filament brands. 

• Shake the bottle vigorously.
• Apply to the desired area by pressing the nib on the bed (activating the inner valve) and spreading as needed.
• Print according to the filament/printer manufacturers recommendations
• Allow to cool and Remove – The Part should become easier to remove after sufficient cooling. If the part is hard to remove, a scraper should be used to assist part removal.
• Clean – Use a wet hard sponge to remove all glue residue. Once the glue layer is wet it will form a white layer which can be easily scrubbed off with an abrasive sponge. Once the layer is completely loose from the glass it can be wiped away with a wet cloth and finally cleaned with a dry paper towel.

SAFETY:

This adhesive is for professional use. Contact with eyes causes serious eye damage, Wash hands and exposed skin thoroughly after handling. 

Tips:

For larger prints a 20 mm brim with multiple layers is recommended

In cases of excess adhesion, it is recommended to wet print bed with a small amount of water slowly work it below the part, this should make part removal easier